TLDR Attached the control stick wire harness connectors to the airframe Details Previously I already connected the wires for both control sticks. However I made a small mistake. The CPC con...

TLDR Installed the boost pump control module Connected cabin heater duct on the copilot side Installed upholstery on the center channel copilot side I planned to just install the boost pu...

TLDR Reinstalled boost pumps and tested for leak Details Previously I sent my boost pumps back to the aeroinno factory for service bulletin. They sent the repaired units back recently so I r...

TLDR Inventoried airmaster propeller Details Received the Airmaster propeller today. It came with 2 boxes well packaged. The small box is the prop hub, wiring harness, controller etc. And th...

TLDR Brake lines Routed the harness in center channel Details Brake lines They are AN3 fittings. I did my best to tighten them in the fuselage: 2 straight fittings to the bulkhead and one...

TLDR Removed the boost pumps from both sides Details Well I guess I spoke too soon last week. The saga on boost pumps are not done yet. Earlier this week Aerospace Innovations (the manufact...

TLDR Made 2 flared fuel line fo boost pump Details So previously I found that the rigid tube connecting the boost pumps to the fuel tank are leaking, I worked on making 2 new rigid tubes o r...

TLDR Installed the rear seat stopper plates Detail With the audio jacks fixed, the wires are in their permanent place. So I went ahead and installed the rear seat stoppers (had to wait becau...

TLDR Installed the comm2 antenna Detail Measured the coax length, and cut the cable to connect with a BNC connector, then installed the AV-74 antenna at the fuselage bottom right below the l...

TLDR Installed 2 inch ducts to cabin heater Installed cabin heater to fuselage Detail I cut the aluminum 2 inch ducts to 4 short tubes and used worm gear clamp to connect them with the cab...