TLDR Continued routeing the wiring harness Put GTR 205xR on the radio rack Detail Wiring harness Continuing yesterday’s work, I got both of the wing connectors routed in place. To put th...

TLDR Started to route the wiring harness Relocated the ELT Detail Routing the wiring harness I will admit, I have been dreading this part of the work. I am super unfamiliar with the elect...

TLDR Continued carpeting in the luggage area Installed the leather on center console Detail Luggage area Not much to report. I continued to carpet the luggage area. Some parts fits the ar...

TLDR Finished installing antenna plates Completed the luggage extension carpeting Detail Antenna plates Previously I finished installing all antenna plates except two: the top plate for c...

TLDR Moved wings to the hangar Detail Onto the truck Rented a 20 FT U-Haul, I moved the wings to the hangar at E16. I started the day at 10 AM to pick up the truck. After fueling, 5 people...

TLDR Installed doubler plates to all antennas Ran wires to all antenna (not connected yet) Detail There are 5 antennas that needed doublers: Top comm Bottom comm GPS1 (GA-35 WAAS) ...

TLDR Installed brake lines from gear legs to fuselage Detail Outside fuselage After pushing the PTFE brake hoses from the gear leg to fuselage, I installed the AN3 fittings on the hose end....

TLDR Installed rudder cable guides Detail Rear guide Drilled a few holes near the rudder cable exit on the rear fuselage, and installed the nylon cable guide. Center guide Cut a slot on...

TLDR Installed control stick on the pilot side Detail This is probably the first piece of avionic that I had some serious work on. I installed the control stick on the pilot side, including...

TLDR Made some support angle for the avionics rack Detail I test fitted the avionics rack and made some support angle for it. I bought the raw aluminum angle material from Home Depot. M...